Desiccant Spool Tumbler Remix with modifiers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Desiccant Spool Tumbler Remix with modifiers
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 60
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Description
A remix of a remix of the Desiccant Spool holder, this 3mf file uses modifiers and process settings to close off the ends of the models while still allowing for full control over the mesh settings for the parts you do want open. I enlarged the nut by 0.5% to make it smoother to screw on and off.
Instructions
Open 3mf in slicer *
Update Filament to whichever one you want to use
OPTIONAL: Update "Process > Global" spare infill density if you want the mesh grid to be large or smaller. I only have small desiccant so went with smaller holes
Slice and check you end up with mesh in the correct places and size.
Print
*If you don't want to use the process settings provided then the important ones that are needed are in the table below
Process settings
Setting | Global Value | Generic Cylinder Values (x3) |
|---|---|---|
Top shell layers | 0 | 3 |
Bottom shell layers | 0 | 3 |
Top shell thickness | 0 | Same |
Bottom shell thickness | 0 | Same |
Sparse infill density | 25% (or similar) | 15% |
Spare infill type | Honeycomb | Same |
Avoid Crossing wall | Enabled (Massively reduces chance of stringing) | Same |
Layer height | 0.12mm | Same |
Notes
You may notice in the pictures there is a slight roughness/missing filament between the infill and the solid parts, especially on the inner lid. It would be possible to fix this with a lot of modifier work or changes to the original model, but I'm happy with it where it is currently. If you have a better fan on your toolhead than what the Qidi Q2 ships with you should get better results.