1 / 9
Silica gel desiccant enclosure for Qidi Combo box qidi q2, plus 4, max — zdjęcie 1
1 / 9

Silica gel desiccant enclosure for Qidi Combo box qidi q2, plus 4, max

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lower the combo box moisture with this silica gel enclosure

Ocena
0 / 5
Polubienia
23
Pobrania
111
Wydruki
0
Wyświetlenia
602
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

Update V2: 

I made a couple of modifications to the original model and uploaded a V2 variant. Features below: 

  • Zig-zag pattern reduces the amount of bridges, prints better and holds smaller silica

  • Rounded corners make it less likely to warp

Neon green is V2. The translucent was the V1 variant. The V2 3MF file is optimized for ASA/ABS printing and you should be able to import it in Orca or Qidi and hit slice and print straight away. 

IMPORTANT:

  • Use detect thin walls in your slicer!

  • Use generous outside brim (5-10mm)

  • Place a towel over the front of your printer 

  • Exhaust FAN OFF

  • Don't stay in the same room with the printer if using ASA/ABS or nylons. 

  • Let the print cool down before removing


Original

I printed this out of PETG but you could use any temperature resistant material you want. PLA is a no-go. 

It doesn't need any supports or screw tapping, the sliding tabs at the top will act as holders and keep it in place. Remove the OEM silica gel holders and place some tape over the holes on the outside. 

I would advise you use a 8mm brim to keep the corners down and auto brim for the sliding tabs. Print in place for both.  Alternatively, you can use mouse ears around the corners, ASA will want to lift up to heat soak your chamber. 

Installation below, lay it flat on the back and then push it upwards from the bottom. The tabs will create a small opposing force so lift from the bottom until it clears the ledge at the back and it sits on it. 

The nice thing is that if the tabs break, you can always print more. I am unsure whether the tabs will take the max heat of the combo box when drying filament or if these will deform. If deformation is encountered, print the sliding tabs out of a different material that is more heat tolerant. 

Tested this with the Elegoo cardboard spool that also has the adapter rings on and it clears it well. This is probably my biggest diameter spool.

Tagi