Hobbyking Avios Bushmule V2 FPV Package

This is a compilation of parts used to outfit the Hobbyking Avios Bushmule V2 with to be FPV ready. The parts are tailored for an analog build. The VTX mount and mast is tailored for the HGLRC 2.5W VTX found on Amazon and matches the length of MMCX wire provided. 

All parts are printed in PETG.

Extra Parts: Zip tie mounts for cable management: 

The parts included are:

1. Battery Cable Relief - this is placed in the cavity behind the battery tray. Glue frugal the zip tie mount on top of it to act as the mount for the battery cable strain relief.

2. Capacitor Mount - fits 2 capacitors. I used 2 1000uF 35V and 2 350uF 35V wired in parallel. Print this in TPU

3. ELRS RX Holder - used to hold a diversity RX mounted in the tail

4. FC Base Plate - the base that the FC mounting plate is screwed onto. Use M3 heat inserts in the hole.

5. FC Mount Plate - a 30.5mm square mounting pattern for many wing style FC. Confirmed fitment for the JHEMCU F405 Wing

6. FPV Camera Pod - 19mm FPV camera mount. This has a concave base meant to be mounted on the nose

7. FPV Camera Pod Flat - This is the same camera mount with a flat base. Mount on the bottom if you want a downward facing camera

8. GPS Box

9. M100 GPS Shim - shim so the GPS lies flat. Put it on the underside and heat shrink it in

10. Motor Prof Base - makes it so the stock motor can be used with normal propellors. The stock motor has a hex socket that can't be removed. This simply covers it up and makes it a flat base.

11. Runcam Thumb 2 Mount

12. VTX Mount - Fits any 30.5mm square VTX. Glue in the open section in the back. The mast is secured using 2 M2 screws. The holes are meant to fit a M2 heat insert.

13. VTX Antenna Mast - mast for the SMA cable extension that's included in the HGLRC 2.5W analog VTX.

14. Wire Management - misc cable management use