1 / 3
Yaesu FTDX10 transceiver front protection cover — zdjęcie 1
1 / 3

Yaesu FTDX10 transceiver front protection cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This two-piece front cover protects the control knobs and LCD when you take your FTDX10 with you for POTA or on vacation

Ocena
0 / 5
Polubienia
3
Pobrania
14
Wydruki
0
Wyświetlenia
92
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I really love my Yaesu FTDX10, but if I'm going out for POTA or was on vacation, I was always a bit afraid that I might damage the control knobs and LCD screen while traveling. 

Since I couldn't find a protective cover for sale or as a sample, I designed one myself. It took quite a few attempts to get a good fit, but I eventually succeeded.
They just slide over the front. The walls are 2mm thick and I enforced the corners with a thick chamfer. So it will protect

I printed it in PETG, but my test prints were in PLA because I still had some old spools lying around. I don't think the material really matters. I used 100% infill.
I created it as two parts because the left side doesn't need much depth but this way it also fits small build plates since the largest piece is only 150mm.

While having the transceiver in use the two parts are also perfect for holding adapters, screws and so on :-)

Tagi