Proxmark 3 RDV4 Antenna Cover Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement annenna cover for the melty official part
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 38
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This is a replacement for the original antenna cover, which is made out of silky plastic that gets melty after a few years.
It's not quite so perfect, it's not trying to be 1:1, and it doesn't fit as satisfyingly as the original. I think the bottom needs to be curved a bit. I might do another revision later.
Suggested print options:
Print with the tip (the thin bottom side) facing down
Use small layer lines if you want to achieve a better look
I used PETG but you can use whatever
Make sure dimensional accuracy is decent, else the inner rails may rub against the antenna PCB, and I cannot promise that that won't destroy your traces if your print comes out real bad and you apply force to close it
Alternative designs: