Proxmark 3 RDV4 Antenna Cover Replacement
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement annenna cover for the melty official part
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 38
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Share Alike
This is a replacement for the original antenna cover, which is made out of silky plastic that gets melty after a few years.
It's not quite so perfect, it's not trying to be 1:1, and it doesn't fit as satisfyingly as the original. I think the bottom needs to be curved a bit. I might do another revision later.
Suggested print options:
Print with the tip (the thin bottom side) facing down
Use small layer lines if you want to achieve a better look
I used PETG but you can use whatever
Make sure dimensional accuracy is decent, else the inner rails may rub against the antenna PCB, and I cannot promise that that won't destroy your traces if your print comes out real bad and you apply force to close it
Alternative designs: