1 / 3
Mark4 FPV Frame – TPU Battery Anti-Twist Side Guides — zdjęcie 1
1 / 3

Mark4 FPV Frame – TPU Battery Anti-Twist Side Guides

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

TPU side guides for the Mark4 frame to prevent LiPo battery twist and slip during aggressive maneuvers.

Ocena
0 / 5
Polubienia
3
Pobrania
9
Wydruki
0
Wyświetlenia
53
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

When pushing hard during freestyle maneuvers, hard landings, or full-throttle punch-outs, LiPo batteries often twist or slide laterally if held only by a standard strap.

These TPU Battery Anti-Twist Side Guides snap directly onto your top plate underneath your main battery strap(s) to lock the battery firmly in place.

In my experience, securing the battery in the center and on one side with an Anti-Twist Guide using a hook-and-loop strap for each is sufficient.

Key Features
  • Anti-Twist & Anti-Slip: Keeps your LiPo battery aligned perfectly straight at all times.

  • Low Profile & Lightweight: Adds negligible weight while offering maximum protection against battery twist and strap displacement.

  • Easy Installation: Uses your existing battery strap(s) and battery pad — no extra hardware or screws needed.

  • Adjustable Fusion File for slightly different dimensions

Provided Files & Customization

  • BatteryAntiTwistSideGuide_38mm.step for (36 mm battery width+2 mm clearance)  

  • BatteryAntiTwistSideGuide_50mm.step for  (48 mm battery width +2 mm clearance)  

Both fit a standard 31 mm frame width (where the guide snaps in).

  • Parametric Fusion 360 File .f3d):  Included for custom dimensions! Easily adjust the following user parameters:

                     BatteryWidth: Measured battery width + desired clearance (e.g., +2 mm).

                     FrameWidth: Width of your top plate where the guide snaps on.

Print Settings & Recommendations
  • Material:                     Flexible TPU (95A or 85A recommended)

  • Layer Height:          0.20 mm

  • Infill:                              25% (Gyroid, Grid, or Rectilinear)

  • Walls/Perimeters: 3 to 4 (for durability against strap tension)

  • Supports:                    Not required / No supports needed

  • Orientation:               Print flat on the build plate

Tagi