Mark4 FPV Frame – TPU Battery Anti-Twist Side Guides
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
TPU side guides for the Mark4 frame to prevent LiPo battery twist and slip during aggressive maneuvers.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 10
- Makes
- 0
- Views
- 54
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
When pushing hard during freestyle maneuvers, hard landings, or full-throttle punch-outs, LiPo batteries often twist or slide laterally if held only by a standard strap.
These TPU Battery Anti-Twist Side Guides snap directly onto your top plate underneath your main battery strap(s) to lock the battery firmly in place.
In my experience, securing the battery in the center and on one side with an Anti-Twist Guide using a hook-and-loop strap for each is sufficient.
Key Features
Anti-Twist & Anti-Slip: Keeps your LiPo battery aligned perfectly straight at all times.
Low Profile & Lightweight: Adds negligible weight while offering maximum protection against battery twist and strap displacement.
Easy Installation: Uses your existing battery strap(s) and battery pad — no extra hardware or screws needed.
Adjustable Fusion File for slightly different dimensions
Provided Files & Customization
BatteryAntiTwistSideGuide_38mm.step for (36 mm battery width+2 mm clearance)
BatteryAntiTwistSideGuide_50mm.step for (48 mm battery width +2 mm clearance)
Both fit a standard 31 mm frame width (where the guide snaps in).
Parametric Fusion 360 File
.f3d): Included for custom dimensions! Easily adjust the following user parameters:
BatteryWidth: Measured battery width + desired clearance (e.g., +2 mm).
FrameWidth: Width of your top plate where the guide snaps on.
Print Settings & Recommendations
Material: Flexible TPU (95A or 85A recommended)
Layer Height: 0.20 mm
Infill: 25% (Gyroid, Grid, or Rectilinear)
Walls/Perimeters: 3 to 4 (for durability against strap tension)
Supports: Not required / No supports needed
Orientation: Print flat on the build plate