1 / 3
129mm chain guard/bash ring — zdjęcie 1
1 / 3

129mm chain guard/bash ring

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A 129mm chain guard for a 28t chainring, four screw holes on 88mm diameter. Fits a White XC 26.0 Lite MTB

Ocena
0 / 5
Polubienia
2
Pobrania
4
Wydruki
0
Wyświetlenia
24
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Don't look a gift horse in the mouth. But if you are gifted a bashed up White XC 26.0 Lite MTB, do look at it and print the needed parts before giving it to your kid. Hopefully this can help avoid tangling trousers into the chainring. I used self tapping screws, something like 4x16mm, to fasten the outer ring from behind the inner ring, after drilling out the rivets that held the old broken one.

This is the outer chain guard. The inner one is probably the same, but I designed this to take self tapping screws instead of the original rivets. If you need to replace both the inner and the outer, you'll need to figure out a better way to fasten them. And drill through the holes that I covered. A lot of good that did - as you can see I used too long screws, poking out the front. Nice.

The outer diameter is 129mm, the four screw holes are on a 88mm diameter circle

Print in PETG or better.

Yes - the chain has been cleaned and oiled now.

Tagi