L6-30 Drok kWh Power Meter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Attention this design assumes you know how to properly handle high voltage safely. I take no responsibility for…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 457
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Attention this design assumes you know how to properly handle high voltage safely. I take no responsibility for anything, should it go wrong.
This design was originally from SpaceGoats. https://www.thingiverse.com/thing:4604901
It did not quite fit the meter securely and I did not want to glue it. I also wanted something a bit different and wanted the outlet to be a bit more secure, so I redesigned the whole thing. The meter snaps in place and the whole box can be assembled with various hardware.
This design uses the following components.
- 3D printed box and lid
- Drok power meter https://www.amazon.com/gp/product/B07YC1XHKQ
- Cable (I had to trim one of the prongs because I actually wanted to use it in another L6-30R) https://www.amazon.com/gp/product/B07MG9C48C
- Leviton L6-30R plug https://www.amazon.com/gp/product/B00002NAT9
I had some hardware laying around. I used self tapping sheet metal screws to hold the lid on the box and I used some machine screws with nuts on the back of the lid to hold the outlet in place.
I am not sure how accurate the meter is, but its better than nothing.
Cheers and happy printing!
Print Settings
Printer Brand:
Robo 3D
Printer:
R1 ABS + PLA Model
Rafts:
No
Supports:
No
Resolution:
300
Infill:
20
Filament: Inland PLA Black
Notes:
3 walls, 3 top and bottom
Category: Electronics