L6-30 Drok kWh Power Meter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Attention this design assumes you know how to properly handle high voltage safely. I take no responsibility for…
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 87
- Makes
- 0
- Views
- 457
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Attention this design assumes you know how to properly handle high voltage safely. I take no responsibility for anything, should it go wrong.
This design was originally from SpaceGoats. https://www.thingiverse.com/thing:4604901
It did not quite fit the meter securely and I did not want to glue it. I also wanted something a bit different and wanted the outlet to be a bit more secure, so I redesigned the whole thing. The meter snaps in place and the whole box can be assembled with various hardware.
This design uses the following components.
- 3D printed box and lid
- Drok power meter https://www.amazon.com/gp/product/B07YC1XHKQ
- Cable (I had to trim one of the prongs because I actually wanted to use it in another L6-30R) https://www.amazon.com/gp/product/B07MG9C48C
- Leviton L6-30R plug https://www.amazon.com/gp/product/B00002NAT9
I had some hardware laying around. I used self tapping sheet metal screws to hold the lid on the box and I used some machine screws with nuts on the back of the lid to hold the outlet in place.
I am not sure how accurate the meter is, but its better than nothing.
Cheers and happy printing!
Print Settings
Printer Brand:
Robo 3D
Printer:
R1 ABS + PLA Model
Rafts:
No
Supports:
No
Resolution:
300
Infill:
20
Filament: Inland PLA Black
Notes:
3 walls, 3 top and bottom
Category: Electronics