F450 type quadcopter top with APM Dampener Mount and taller arms
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I liked the design, but the mount for the apm was a little flimsy and a little small. So I took two items and mated…
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 162
- Wydruki
- 0
- Wyświetlenia
- 616
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I liked the design, but the mount for the apm was a little flimsy and a little small. So I took two items and mated them together. I also made the top plate 3mm instead of the original 2mm to add additional strength.
There is also a file for the arms that are 6mm taller because I wanted to fit a large battery in the middle rather than underneath where my gimbal would go.
Also added a file with the gps post already on the plate, and a file for the bottom plate with holes enlarged for standard gimbal attachment:)
The apm mount that I used is located here http://www.thingiverse.com/thing:160655
It is the Omnimac_APM_Mount_v1.5_bottom_plate file so the top plate must be the Omnimac_APM_Mount_v1.5_top_plate file
Thank you both for these wonderful files!
Print Settings
Printer Brand:
Robo 3D
Printer:
R1 ABS + PLA Model
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
.2 or better
Infill:
20%
Notes:
For dampeners use the 9mm x 13mm or earplugs :)
Category: R/C Vehicles