Universal Telescope Rail Drop-On Desk Base – Vixen & Losmandy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tool-free padded desk base for common Vixen and Losmandy D-style telescope rails; no supports required.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 35
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution — Share Alike
Universal drop-on desk rest for rail-mounted telescopes
One reusable standard for the two common telescope dovetail families. Lower the telescope vertically until the outer load-bearing edges of its bottom rail rest on the broad TPU pads. Nothing slides into a saddle and there is no clamp, knob, screw, or tool.
Compatibility
• Vixen-style rails, typically around 44 mm wide
• Losmandy D-style rails, nominally 3 inches / 76.2 mm
• Other straight bottom rails approximately 35–90 mm wide
• Contact zones: 12–47 mm from the centerline on each side
• Center relief: 24 mm wide × 10 mm deep
• Footprint: 180 × 200 mm for a 220 × 220 mm print bed
Included files
• PETG/ASA rigid base STL
• TPU pads and feet STL
• Parametric OpenSCAD source
• Preview image, README and mesh-validation report
Rigid base print settings
• PETG or ASA; 0.20 mm layers
• 5 walls; 6 top/bottom layers
• 30–35% gyroid or cubic infill
• Large flat face on the build plate
• No supports; brim optional
TPU kit print settings
• 95A TPU; 0.20 mm layers
• 3 walls; 100% infill; 20–30 mm/s
• Print flat with pegs upward; no supports
Assembly
Push the TPU parts peg-first into the matching blind sockets. Peg interference is 0.15 mm and is adjustable in the OpenSCAD source.
Safety and fit
This is a friction-supported desk rest only—not a mount saddle, transport fixture, or restraint. Mesh validation cannot prove real-world stability. Confirm both rail edges sit fully on the TPU zones and all hardware clears the center relief. First test on a padded floor with one hand on the telescope. The complete telescope’s center of mass must remain inside the base footprint. Do not use with a rail-less telescope, an out-of-range rail, or an assembly not physically tested.
