1 / 1
Universal Telescope Rail Drop-On Desk Base – Vixen & Losmandy — image 1

Universal Telescope Rail Drop-On Desk Base – Vixen & Losmandy

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Tool-free padded desk base for common Vixen and Losmandy D-style telescope rails; no supports required.

Rating
0 / 5
Likes
0
Downloads
4
Makes
0
Views
37
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

Universal drop-on desk rest for rail-mounted telescopes

One reusable standard for the two common telescope dovetail families. Lower the telescope vertically until the outer load-bearing edges of its bottom rail rest on the broad TPU pads. Nothing slides into a saddle and there is no clamp, knob, screw, or tool.

Compatibility

• Vixen-style rails, typically around 44 mm wide

• Losmandy D-style rails, nominally 3 inches / 76.2 mm

• Other straight bottom rails approximately 35–90 mm wide

• Contact zones: 12–47 mm from the centerline on each side

• Center relief: 24 mm wide × 10 mm deep

• Footprint: 180 × 200 mm for a 220 × 220 mm print bed

Included files

• PETG/ASA rigid base STL

• TPU pads and feet STL

• Parametric OpenSCAD source

• Preview image, README and mesh-validation report

Rigid base print settings

• PETG or ASA; 0.20 mm layers

• 5 walls; 6 top/bottom layers

• 30–35% gyroid or cubic infill

• Large flat face on the build plate

• No supports; brim optional

TPU kit print settings

• 95A TPU; 0.20 mm layers

• 3 walls; 100% infill; 20–30 mm/s

• Print flat with pegs upward; no supports

Assembly

Push the TPU parts peg-first into the matching blind sockets. Peg interference is 0.15 mm and is adjustable in the OpenSCAD source.

Safety and fit

This is a friction-supported desk rest only—not a mount saddle, transport fixture, or restraint. Mesh validation cannot prove real-world stability. Confirm both rail edges sit fully on the TPU zones and all hardware clears the center relief. First test on a padded floor with one hand on the telescope. The complete telescope’s center of mass must remain inside the base footprint. Do not use with a rail-less telescope, an out-of-range rail, or an assembly not physically tested.

Tags