Companion Cube Corner Sleeves
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sleeves that fit over the corners of your SteamMachine companioncube enclosure byJaron!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These are sleeves that snap over the existing companion cube by Jaron hide the seams.
Currently there's no version with cutouts for the front buttons, I intend to release them as updates to this model as soon as I can. Similarly i would like to design sleeves for the edge pieces to make the cube even more seamless.
PRINT ADVICE, READ CAREFULLY TO AVOID MISPRINTS:
Because of the thin nature they can be a challenge to print, be sure to print with supports, and arachnid+wide line width.
(overhang threshold 80 + snug normal support type)
check the slicer to see if every wall is 2 lines thick, without infill line in certain parts of the print.
(see example picture with blue arrow)
While it is possible to load up to 6 corners on one 256 buildplate, its recommended to try printing one and checking if the print resulted in a flawless result.
The current fit is flush but could be tighter depending on how flexible the filament is you'reprinting with.
(the STL is scaled at 101.3%, verify the length with the example pictureto be sure!)