Companion Cube Corner Sleeves
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Sleeves that fit over the corners of your SteamMachine companioncube enclosure byJaron!
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 142
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These are sleeves that snap over the existing companion cube by Jaron hide the seams.
Currently there's no version with cutouts for the front buttons, I intend to release them as updates to this model as soon as I can. Similarly i would like to design sleeves for the edge pieces to make the cube even more seamless.
PRINT ADVICE, READ CAREFULLY TO AVOID MISPRINTS:
Because of the thin nature they can be a challenge to print, be sure to print with supports, and arachnid+wide line width.
(overhang threshold 80 + snug normal support type)
check the slicer to see if every wall is 2 lines thick, without infill line in certain parts of the print.
(see example picture with blue arrow)
While it is possible to load up to 6 corners on one 256 buildplate, its recommended to try printing one and checking if the print resulted in a flawless result.
The current fit is flush but could be tighter depending on how flexible the filament is you'reprinting with.
(the STL is scaled at 101.3%, verify the length with the example pictureto be sure!)