Peak Design Mobile to Capture V3 Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapt a magnetic mount for Peak Design's Mobile Case standard straight to their Capture V3 clip product in a single part
- Ocena
- 2 / 5
- Polubienia
- 23
- Pobrania
- 123
- Wydruki
- 0
- Wyświetlenia
- 1693
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
Update 6/29/22: Added a version with a centered ¼-20" thread and no boss (i.e., MagSafe compatible). Use caution – this will be less secure than the SlimLink version.
Update 4/27/22: Added a version with a centered ¼-20" thread
A magnetic mount to adapt Peak Design's Mobile Case standard straight to their Capture V3 clip product in a single part.
Requires 4x 10mm x 3mm refrigerator magnets and a pause at the appropriate layer to embed them in the print.
I recommend you use Peak Design's Mobile case and retain the small square boss on the phone side of this adapter – this will make the magnet joint much stronger by preventing sliding in any direction.
This should also be compatible with MagSafe natively without a Peak Design case if you remove the boss, but I haven't tested it and wouldn't recommend it for actually carrying a phone on a Capture – not secure enough IMO.
My first print so far with this design was with:
- Prusament PLA Galaxy Silver
- 0.15mm layers, QUALITY preset
- 4 perimeters
- 30% gyroid infill
- supports to the base only
- printed with the boss/phone side down on the plate