1 / 1
Himiway A7 Pro — MIK Adapter Rack Stopper Blocks (parametric) — zdjęcie 1

Himiway A7 Pro — MIK Adapter Rack Stopper Blocks (parametric)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Printable replacement for Himiway's MIK-adapter rack stopper blocks (A7 Pro). Parametric, reverse-engineered.

Ocena
0 / 5
Polubienia
1
Pobrania
1
Wydruki
0
Wyświetlenia
81
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Reverse-engineered, 3D-printable replacement for the small metal "stopper blocks" Himiway ships to mount a standard MIK adapter plate onto the MIK-compatible rear rack of the Himiway A7 Pro, and probably other Himiway models assuming they use the same rack.

Why they're needed: a standard MIK adapter plate is ~100 mm wide at the end that drops into the rack's angled cutout, but the A7 Pro rack gap is only ~94 mm. Himiway's fix is to remove the plate's wide plastic stopper and bolt two of these narrower metal blocks onto the plate's inner mounting holes, pulling the stop faces inboard so the basket seats.

I reverse-engineered the geometry from photos, caliper measurements of the stock parts, and Himiway's official installation videos, then built a fully parametric OpenSCAD model so the fit can be tuned. Himiway shows the metal-block install in the video on their A7 Pro rear basket product page (linked under References below).

Included files:

  • mik-himiway-block.stl — ready to slice

  • mik-himiway-block.scad — parametric source (edit rack gap, hole spacing, groove size, chamfers, etc.)

Fit basis (measured on my A7 Pro):

  • Inner mounting holes: 53 mm center-to-center

  • Rack gap ~94 mm, so each block reaches 19.5 mm outward from its bolt for a 92 mm assembled span (~1 mm/side clearance)

  • Adapter groove for the stem: 14 mm wide x 3 mm deep

  • Screw 5 mm; head recess 10 mm x 4 mm; block stands 13 mm above the plate

Printing:

  • Print 2 (one per side). The part is symmetric across its width, so the same STL works on both sides — just rotate it 180 degrees.

  • Orientation: cap-top-down (as exported) is essentially self-supporting. I printed with supports only for the floor of the counterbored screw hole; that is optional and you can likely skip it.

  • Heads up: the stem width is a tight fit on my printer. Depending on your printer's tolerances you may need to scale the part down slightly (or reduce stem_width in the .scad) to get the stem into the 14 mm groove.

  • This is a load-bearing safety part: use a tough material (PETG/ASA/ABS or nylon), 4–5 perimeters, high/100% infill, and verify it holds before trusting a basket to it.

References:

Not affiliated with Himiway or Basil. Dimensions are best-effort from measurements — verify fit before relying on it.

Tagi