1 / 2
Schwalbe Airmax Pro clik valve adapter - remix, original from @Michele Barp — zdjęcie 1
1 / 2

Schwalbe Airmax Pro clik valve adapter - remix, original from @Michele Barp

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This adapter can be used to mount a clik valve head with schrader thread to Schwalbe Airmax Pro tire pression gauge.

Ocena
0 / 5
Polubienia
0
Pobrania
21
Wydruki
0
Wyświetlenia
212
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Remix, original from @Michele Barp

Since I don't own the Schwalbe gauge, I cannot fully test this design. I just thought the adapter from @Michele Barp could be designed a little bit more elegantly. I simply adopted the thread on the air pressure gauge side exactly as it was from the previous model. Perhaps the thread could be shortened a bit more?

Original Desciption: “This adapter can be used to mount a clik valve head with schrader thread to Schwalbe Airmax Pro tire pression gauge. Print it at 103% scale to compensate PLA shrinking.”

What I’ve changed is that the Clik Valve pump adapter can be screwed on directly. The Schwalbe / SKS CLIK Valve SCV pump head adapter is required: https://www.sks-germany.com/en/Products/Pumps/CLIK-TEC-Adapter-for-Pump-Heads.htm?a=article&ProdNr=12068&p=1008. This part works and has been tested by me.

The upper part of the Schwalbe / SKS CLIK Valve SCV tire pump head adapter (rubber-coated) can be easily unscrewed from the lower part with the Schrader adapter (threaded part). When assembling the printed adapter, it is important to reinsert the small rubber seal which is located inside!

Tagi