Prusa LACK enclosure gap fillers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Credits to cisardom for thing https://www.thingiverse.com/thing:2864118 and Mikolas Zuza for the guide…
- Ocena
- 4,333 / 5
- Polubienia
- 74
- Pobrania
- 362
- Wydruki
- 2
- Wyświetlenia
- 2683
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Credits to cisardom for thing
https://www.thingiverse.com/thing:2864118
and Mikolas Zuza for the guide
https://blog.prusaprinters.org/cheap-simple-3d-printer-enclosure/
I was a bit unhappy with the final build because cutting the plexi to 440 x 440mm left a gap between the LACK and plexi of aprox 5mm along each leg/vertical edge of the plexi. Due to the design of the plexi holders there will also be a 2mm gap on the horizontal edges.
So I made some simple gap fillers that fit quite nicely on my build. The STL files are for 3mm plexi cut to 440x440mm.
I attached a parametric 3ds file where you can adjust for plexi thickness and plexi length to some small degree.
NB - it will not change the length of the rails as they are static to the measures of the IKEA LACK. Adjusting L - length will simly make the groove deeper or shallower. Therefore you can only set values between 440mm and 432mm.
I also had to use a 1,5mm spacer in betweed the legs and bottom parts to make everything fit properly.
What to print:
You'll need two of each vertical fillers and four horizontal for each of the three sides. Havent made any for the door yet.
Print instructions
Category: 3D Printing Print Settings
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: Doesn't Matter
Supports: No
Infill: 15%