Prusa LACK enclosure gap fillers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Credits to cisardom for thing https://www.thingiverse.com/thing:2864118 and Mikolas Zuza for the guide…
- Rating
- 4.333 / 5
- Likes
- 74
- Downloads
- 362
- Makes
- 2
- Views
- 2,683
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Credits to cisardom for thing
https://www.thingiverse.com/thing:2864118
and Mikolas Zuza for the guide
https://blog.prusaprinters.org/cheap-simple-3d-printer-enclosure/
I was a bit unhappy with the final build because cutting the plexi to 440 x 440mm left a gap between the LACK and plexi of aprox 5mm along each leg/vertical edge of the plexi. Due to the design of the plexi holders there will also be a 2mm gap on the horizontal edges.
So I made some simple gap fillers that fit quite nicely on my build. The STL files are for 3mm plexi cut to 440x440mm.
I attached a parametric 3ds file where you can adjust for plexi thickness and plexi length to some small degree.
NB - it will not change the length of the rails as they are static to the measures of the IKEA LACK. Adjusting L - length will simly make the groove deeper or shallower. Therefore you can only set values between 440mm and 432mm.
I also had to use a 1,5mm spacer in betweed the legs and bottom parts to make everything fit properly.
What to print:
You'll need two of each vertical fillers and four horizontal for each of the three sides. Havent made any for the door yet.
Print instructions
Category: 3D Printing Print Settings
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: Doesn't Matter
Supports: No
Infill: 15%