1 / 8
Nomad 19 portable antenna mast STL files for umbrella stand (or for a hitch mount) — zdjęcie 1
1 / 8

Nomad 19 portable antenna mast STL files for umbrella stand (or for a hitch mount)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

DX Engineering Nomad 19 Mast Mount Bushing Set — for umbrella stand or hitch mount

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
37
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution

DX Engineering Nomad 19 Mast Mount Bushing Set — for umbrella stand (or for a hitch-mounted receiver)

Reference pipe (yard umbrella base pole):
OD 53.09mm (2.090"), ID 50.72mm (1.997"), wall thickness ~1.14mm (0.045")

Top Bushing:  Guide bushing for mounting a DX Engineering Nomad 19 telescoping mast inside a standard steel yard-umbrella pole (2.090" OD / 1.997" ID). Sits at the top of the tube to center and stabilize the mast. Stepped design: a 15mm-tall lower collar (49.22mm OD) presses into the tube, topped by a 10mm-tall flange (67.09mm OD) that rests on the tube's rim. A 38.22mm through-bore lets the Nomad 19's base section pass through snugly. Total height 25mm. Dimensions tuned through physical test-fit iterations for a proper snug-but-removable fit — print in PETG for UV/outdoor durability.

Test Ring
A quick-print calibration ring for verifying fit before committing to the full bushing/collar set. 10mm tall, 49.22mm OD (fits inside a 2.090" OD / 1.997" ID steel tube), 38.22mm ID (mast passes through). Useful reference piece if you're adapting this design to a different tube size — print it first and adjust OD/ID in small increments before printing the full parts.

Base/Inner Collar
Loose-fit support collar for the bottom of the tube, keeping the Nomad 19 mast centered without binding as it's inserted/removed. 20mm tall, 48.22mm OD, 38.22mm ID (10mm radial clearance over the mast's base diameter for easy sliding fit). Companion part to the top bushing above.

Unun Collar (square loop)
Clamp-on collar that fits around the outside of the steel mounting tube (2.090" OD) to anchor a zip-tied unun or choke at the base of the antenna. 20mm tall, 5mm wall thickness, 64.5mm OD, with a 15×15mm square loop for routing a zip tie or strap. ID may need slight adjustment (54.5mm starting point) depending on your specific tube's actual OD — test fit before final printing.

Printed in PETG. No supports needed.

Tagi