1 / 8
Nomad 19 portable antenna mast STL files for umbrella stand (or for a hitch mount) — image 1
1 / 8

Nomad 19 portable antenna mast STL files for umbrella stand (or for a hitch mount)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

DX Engineering Nomad 19 Mast Mount Bushing Set — for umbrella stand or hitch mount

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
37
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution

DX Engineering Nomad 19 Mast Mount Bushing Set — for umbrella stand (or for a hitch-mounted receiver)

Reference pipe (yard umbrella base pole):
OD 53.09mm (2.090"), ID 50.72mm (1.997"), wall thickness ~1.14mm (0.045")

Top Bushing:  Guide bushing for mounting a DX Engineering Nomad 19 telescoping mast inside a standard steel yard-umbrella pole (2.090" OD / 1.997" ID). Sits at the top of the tube to center and stabilize the mast. Stepped design: a 15mm-tall lower collar (49.22mm OD) presses into the tube, topped by a 10mm-tall flange (67.09mm OD) that rests on the tube's rim. A 38.22mm through-bore lets the Nomad 19's base section pass through snugly. Total height 25mm. Dimensions tuned through physical test-fit iterations for a proper snug-but-removable fit — print in PETG for UV/outdoor durability.

Test Ring
A quick-print calibration ring for verifying fit before committing to the full bushing/collar set. 10mm tall, 49.22mm OD (fits inside a 2.090" OD / 1.997" ID steel tube), 38.22mm ID (mast passes through). Useful reference piece if you're adapting this design to a different tube size — print it first and adjust OD/ID in small increments before printing the full parts.

Base/Inner Collar
Loose-fit support collar for the bottom of the tube, keeping the Nomad 19 mast centered without binding as it's inserted/removed. 20mm tall, 48.22mm OD, 38.22mm ID (10mm radial clearance over the mast's base diameter for easy sliding fit). Companion part to the top bushing above.

Unun Collar (square loop)
Clamp-on collar that fits around the outside of the steel mounting tube (2.090" OD) to anchor a zip-tied unun or choke at the base of the antenna. 20mm tall, 5mm wall thickness, 64.5mm OD, with a 15×15mm square loop for routing a zip tie or strap. ID may need slight adjustment (54.5mm starting point) depending on your specific tube's actual OD — test fit before final printing.

Printed in PETG. No supports needed.

Tags