Tulips in Stained-glass Style
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a two-part Tulip stained-glass styled window art.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This Tulip stained-glass styled window art was done a while back in anticipation of Spring in North America. There are two parts to it, a blue part and a red/yellow part. The models use a total of just four filaments so it is possible to do this without an AMS unit by swapping filaments on any FDM printer that supports swaps or pauses.
The two parts are mirror images of each other so that they can be mated flat side to flat side. I use a little super glue around the edges and a few of the darker spots as too much glue can lead to color changes.
Feel free to substitute filaments that have similar colors and TD values. I use PETG for heat resistance, but all PLA can be substituted for these, if no extreme sun exposure can be guaranteed.
These models are very thin, use caution when getting them off the build plate. With PETG on a standard textured PEI plate be sure to cool the plate completely and/or use some glue stick as a release agent to ease removal from the build plate. Rushing removal can lead to disaster - I know, I've ruined some being impatient.
Part 1: Blue
Project: Tulips_1_Blue.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 150x157.99mm in size
You may print at higher layer heights below the Base Thickness of 0.32mm
The Max allowed Thickness is 1.28mm and the Actual Thickness is 0.8mm
PETG GeeeTech Transparent Transmission Distance: 100
PETG Kaaber Blue Transmission Distance: 3.3
This print uses 2 unique filaments
Swap Instructions:
Start with Transparent
At layer #4 (0.4mm) swap to Blue for the rest.
Part 2
Project: Tulips_1_RedYellow.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 150x157.99mm in size
You may print at higher layer heights below the Base Thickness of 0.32mm
The Max allowed Thickness is 1.6mm and the Actual Thickness is 1.12mm
PETG GeeeTech Transparent Transmission Distance: 100
PETG Bambu HF Yellow Transmission Distance: 4
PETG Kaaber Red Transmission Distance: 6.5
This print uses 3 unique filaments
Swap Instructions:
Start with Transparent
At layer #4 (0.4mm) swap to Yellow
At layer #7 (0.64mm) swap to Red for the rest.