1 / 7
Gramophone Trinket Box + Matching Charm — Victrola Horn Phonograph — zdjęcie 1
1 / 7

Gramophone Trinket Box + Matching Charm — Victrola Horn Phonograph

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A horn-gramophone trinket box with a front-loading drawer hidden in the cabinet, plus the same phonograph shrunk into a

Ocena
0 / 5
Polubienia
2
Pobrania
9
Wydruki
0
Wyświetlenia
41
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial

A wind-up horn gramophone that opens. The cabinet under the horn hides a front-loading drawer — pull the knob and it slides straight out. Rings, guitar picks, SD cards, pills, one very small secret. The horn, tonearm and record deck stay solid and permanent; only the drawer moves.

the box, drawer half open

And the same gramophone shrunk down to wear. The charm is the identical phonograph at earring scale with a jump-ring bail fused into the horn rim, so the box and the earring read as a matched set.

the charm

What's in the download

File

What it is

Size

victrola_box_body.stl

Gramophone body with the drawer pocket

54 × 52 × 66 mm

victrola_box_drawer.stl

Slide-in drawer, styled faceplate + knob

23 × 26 × 12 mm

victrola_earring_print.stl

Wearable charm with bail

25 × 24 × 34 mm

drawer out

Assembly: none. Print the two box parts, slide the drawer in. For the charm, thread a jump ring through the bail and hang it from an ear wire or a chain. No supports, no glue, no hardware.

Print notes

  • Both parts print cabinet-down, flat on the bed — no supports anywhere.

  • The drawer is modelled with a running clearance; print it in the same material as the body so the fit lands where it was tuned.

  • 0.2 mm layers are fine on the box. Drop to 0.12 mm for the charm — at 34 mm tall, the horn scallops and the tonearm are near the limit of what a 0.4 mm nozzle resolves, and coarse layers blob the horn lip.

  • The tonearm foot is the fragile spot on the charm. It is welded into the cabinet back wall with a tapered neck and a buttress fin (the first print snapped there before the weld). Don't scale the charm down.

  • Any filament. PLA is fine; the photo is PLA.

front

The .scad is attached, and it drives both wear formats plus a 1.35× pendant scale.

Tagi