WLED Hexagon Lamp — ESP32/WS2801 Controller & Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
ESP32/WS2801 WLED controller & enclosure for NickiDotDK's Hexagon LED Lamp.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 60
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a controller/enclosure add-on for NickiDotDK's Hexagon LED Lamp — print that model first, this listing only covers the electronics enclosure.
Full build guide with schematic, Gerber files, BOM, and WLED config: https://github.com/ZimtJohnstern/wled-hexagon-lamp
Bill of Materials (BOM)
To build this project, you will need the following components:
| Component | Qty | Description / Specifications |
| :--- | :---: | :--- |
| [Microcontroller] | Qty: 1 | ESP32 DevBoard
| [LED Strip] | Qty: 1 | WS2801 (5 Meters)
| IC1: [Quad Bus Buffer] | Qty: 1 | SN74AHCT125N
| F1: [Fuse Holder] | Qty: 1 | 250 V / 10 A
| C1, C2: [Electrolytic Cap] | Qty: 2 | 470 µF
| C3: [Capacitor] | Qty: 1 | 100 nF
| R1, R2: [Resistor] | Qty: 2 | 100 Ω
| U$1: [Terminal Block 2-pin] | Qty: 1 | 2828XX-2282837-2
| U$2: [Terminal Block 4-pin] | Qty: 1 | 2828XX-4282837-4
| : [Power Supply] | Qty: 1 | 5V / 10A
| : [Filament] | Kingroon PETG (for enclosure)
---
Print settings:
Material: PETG,
Infill: 20%
Support: generally not needed — only generate supports at the board clamp (Clamp_in/Clamp_out) if your slicer flags overhang issues there.
Credit: hexagon frame design by NickiDotDK, licensed CC BY-NC 4.0.