Cable Chain Rollercoaster Clips RemiX
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
[PTFE ROLLERCOASTER MOD] x [Bambu Printers Cable Chain PTFE Clip]
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I found SteveC's rollercoaster thin body was a bit weak on clamp so i mixed it with 4cmclean's clips.
Changed chamfer a bit and made the lower jaw a little higher.
It's a bit difficult to install but once in place it feels solid.
For printing, orient clamps and cups like the pic and holders just vertical C clamp up.
For installing, engage the top jaw first then twist it around the drag chain while pulling a bit the lower jaw.
NO NEED TO DISASSEMBLE
Updates
2026/08/05: reorganized post and added open clips
2026/09/12: was not satisfied with cup holders as it was a pain to print so i made it different. As my printer is out of service until i receive my parts, i didn't print it so it's in alpha state.
2026/09/21: screw was too big, fixed the model, printing rn.
2026/09/22: fixed screw width and length + minor fixes + cosmetics + new S/M/L joints
2026/10/04: minor fixes + touchmarks
2026/10/24: tips