Cable Chain Rollercoaster Clips RemiX
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
[PTFE ROLLERCOASTER MOD] x [Bambu Printers Cable Chain PTFE Clip]
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 142
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I found SteveC's rollercoaster thin body was a bit weak on clamp so i mixed it with 4cmclean's clips.
Changed chamfer a bit and made the lower jaw a little higher.
It's a bit difficult to install but once in place it feels solid.
For printing, orient clamps and cups like the pic and holders just vertical C clamp up.
For installing, engage the top jaw first then twist it around the drag chain while pulling a bit the lower jaw.
NO NEED TO DISASSEMBLE
Updates
2026/08/05: reorganized post and added open clips
2026/09/12: was not satisfied with cup holders as it was a pain to print so i made it different. As my printer is out of service until i receive my parts, i didn't print it so it's in alpha state.
2026/09/21: screw was too big, fixed the model, printing rn.
2026/09/22: fixed screw width and length + minor fixes + cosmetics + new S/M/L joints
2026/10/04: minor fixes + touchmarks
2026/10/24: tips