1 / 10
Faketec V4 case outdoor solar node — zdjęcie 1
1 / 10

Faketec V4 case outdoor solar node

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Case for faketec V4 with thermal shield and 18650 battery holder

Ocena
0 / 5
Polubienia
0
Pobrania
12
Wydruki
0
Wyświetlenia
157
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Simple enclosure for the Faketec V4 outdoor solar node, with included thermal shield and ventilation.

My part list:

  • Faketec V4

  • 18650 Li-ion battery

  • SD05CRMA MPPT Solar Charge Controller, connected to a small solar panel. I'm testing a 2W 6V panel on a window, and it has run for 2 weeks and kept charging without any problem. You can also use a TP4056 as a simple charger.

  • 2x M2 x 3mm brass inserts, for the Faketec

  • 2x M2.5 x 3mm brass inserts, for the BMP280

  • few M2 (max 16 pcs) and M2.5 screws ( 2pcs),

  • 4x M2 screws two with inserts and two without because of possible short

  • BMP280 3.3V Digital Barometric Pressure/Altitude Sensor, mounted on the top piece

  • IPEX interface 868/915MHz dual-band antenna, high gain 5dBi (as shown in the picture)

  • XH 2.54 2-pin connector, for easy connection of everything

  • Self-fusing silicone tape (weatherproof seal), for antenna isolation

UPDATE:

  • added module for 1x 1W 6V solar panel cca. 110mm x 60mm basic version from aliexpress, you mount it on front and add M3 screw with nut to hold it and lock panel with 2x M2 screws. I will add photos later.

You'll have to drill the hole for the solar panel cable yourself, since everyone uses a different location and cable diameter.
Comment if you want .step file for tinkering or creating own modules.
The top system makes it easy to design your own modules — for example, instead of a thermal shield you could make a solar panel holder, etc.

UPDATE:

  • added 2 x 1W panel module

I will add real photos later after testing.

Tagi