Faketec V4 case outdoor solar node
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for faketec V4 with thermal shield and 18650 battery holder
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 12
- Makes
- 0
- Views
- 158
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple enclosure for the Faketec V4 outdoor solar node, with included thermal shield and ventilation.
My part list:
Faketec V4
18650 Li-ion battery
SD05CRMA MPPT Solar Charge Controller, connected to a small solar panel. I'm testing a 2W 6V panel on a window, and it has run for 2 weeks and kept charging without any problem. You can also use a TP4056 as a simple charger.
2x M2 x 3mm brass inserts, for the Faketec
2x M2.5 x 3mm brass inserts, for the BMP280
few M2 (max 16 pcs) and M2.5 screws ( 2pcs),
4x M2 screws two with inserts and two without because of possible short
BMP280 3.3V Digital Barometric Pressure/Altitude Sensor, mounted on the top piece
IPEX interface 868/915MHz dual-band antenna, high gain 5dBi (as shown in the picture)
XH 2.54 2-pin connector, for easy connection of everything
Self-fusing silicone tape (weatherproof seal), for antenna isolation
UPDATE:
added module for 1x 1W 6V solar panel cca. 110mm x 60mm basic version from aliexpress, you mount it on front and add M3 screw with nut to hold it and lock panel with 2x M2 screws. I will add photos later.
You'll have to drill the hole for the solar panel cable yourself, since everyone uses a different location and cable diameter.
Comment if you want .step file for tinkering or creating own modules.
The top system makes it easy to design your own modules — for example, instead of a thermal shield you could make a solar panel holder, etc.
UPDATE:
added 2 x 1W panel module
I will add real photos later after testing.
