1 / 3
Cisco Meraki MR86 to US One-Gang Box Mounting Adapter — zdjęcie 1
1 / 3

Cisco Meraki MR86 to US One-Gang Box Mounting Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An adapter so you can mount an MR86 to a US One-Gang Box

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
27
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Open Community License v1.1 + General Attribution v1

This adapter allows the factory Cisco Meraki MR86 mounting bracket to be attached to a standard US one-gang electrical box. It uses the standard 83.3 mm one-gang screw spacing and an MR86 bracket mounting pattern of 117 mm horizontal × 98 mm vertical.

The center opening provides clearance for the Ethernet cable and connector. This model is intended for outdoor use and should be printed in PETG, ASA, or another UV- and heat-resistant material. Do not use PLA outdoors.

Required hardware

For attaching the adapter to the one-gang box:

  • 2 × 6-32 machine screws

  • Approximately 25–32 mm (1–1¼ inch) long, depending on the box depth

For attaching the MR86 factory bracket:

  • 4 × M4 heat-set brass inserts

  • Approximately 5.2 mm outside diameter

  • 6 mm long

  • 4 × M4 machine screws

  • Approximately 10–12 mm long

  • Stainless-steel hardware is recommended for outdoor installations

Install the heat-set inserts from the front side of the printed adapter using a soldering iron or heat-set insert tool. Allow them to cool completely before installing the bracket.

Suggested print settings

  • Material: PETG or ASA

  • Layer height: 0.20–0.24 mm

  • Walls: 5–6

  • Top and bottom layers: 5–6

  • Infill: 35–50%

  • Print flat

  • No supports required

Tagi