1 / 3
Cisco Meraki MR86 to US One-Gang Box Mounting Adapter — image 1
1 / 3

Cisco Meraki MR86 to US One-Gang Box Mounting Adapter

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An adapter so you can mount an MR86 to a US One-Gang Box

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
27
Reviews
0

Updated at source:

Model information

License
Open Community License v1.1 + General Attribution v1

This adapter allows the factory Cisco Meraki MR86 mounting bracket to be attached to a standard US one-gang electrical box. It uses the standard 83.3 mm one-gang screw spacing and an MR86 bracket mounting pattern of 117 mm horizontal × 98 mm vertical.

The center opening provides clearance for the Ethernet cable and connector. This model is intended for outdoor use and should be printed in PETG, ASA, or another UV- and heat-resistant material. Do not use PLA outdoors.

Required hardware

For attaching the adapter to the one-gang box:

  • 2 × 6-32 machine screws

  • Approximately 25–32 mm (1–1¼ inch) long, depending on the box depth

For attaching the MR86 factory bracket:

  • 4 × M4 heat-set brass inserts

  • Approximately 5.2 mm outside diameter

  • 6 mm long

  • 4 × M4 machine screws

  • Approximately 10–12 mm long

  • Stainless-steel hardware is recommended for outdoor installations

Install the heat-set inserts from the front side of the printed adapter using a soldering iron or heat-set insert tool. Allow them to cool completely before installing the bracket.

Suggested print settings

  • Material: PETG or ASA

  • Layer height: 0.20–0.24 mm

  • Walls: 5–6

  • Top and bottom layers: 5–6

  • Infill: 35–50%

  • Print flat

  • No supports required

Tags