Glove holder / Handschuhhalter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for your gardening or work gloves
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 54
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
I made these gloveholders for my gardening and work gloves.
There are two versions of the holder, a larger one for sturdiere gloves and a smaller one for lighter gloves.
I printed them in PCTG, which works fine. I don't know yet how much creep will occur with PCTG or PETG over time, but if this gets a problem I will switch to ASA.
For mounting I reccomend to use flathead screws and large washers, to prevent splitting or the mounting tabs to break off.
Parameters:
Nozzle diameter: 0,4mm
Perimerters: 2
Infill: there is basicall no infill with 2 perimerters
In Prusa slicer I used a modifier box to add Fuzzy skin in the area, where the gloves go, to increase friction and better clamping of the gloves. I used point distance 0,6mm and thickness 0,4mm for this.