Glove holder / Handschuhhalter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holder for your gardening or work gloves
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 0
- Views
- 54
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
I made these gloveholders for my gardening and work gloves.
There are two versions of the holder, a larger one for sturdiere gloves and a smaller one for lighter gloves.
I printed them in PCTG, which works fine. I don't know yet how much creep will occur with PCTG or PETG over time, but if this gets a problem I will switch to ASA.
For mounting I reccomend to use flathead screws and large washers, to prevent splitting or the mounting tabs to break off.
Parameters:
Nozzle diameter: 0,4mm
Perimerters: 2
Infill: there is basicall no infill with 2 perimerters
In Prusa slicer I used a modifier box to add Fuzzy skin in the area, where the gloves go, to increase friction and better clamping of the gloves. I used point distance 0,6mm and thickness 0,4mm for this.