Thunder Skateboard Trucks Slider

These sliders are build for Thunder trucks. They extend the baseplate by either 8mm or 11mm (your choice) to help in nose and tail slides, like "rails" but for your baseplates. Please try them and let me know what you think.

Printing info. The ones in the pictures are printed 100% fill in Creality hyper PLA, I printed them upside down so as not to have supports in the nut holes. They have worked great so far, I have skated them probably 15 times now. I'm going to try some PA12 ones next and I will update after I skate them a bunch. (Update: PA12 broke one first session, I ordered them from a printer company so I can’t comment on settings but I did notice the nut holes seemed too small, I think I will stick with the PLA)

Note: Assembly is tricky, but it allows them to be sturdy! You will need 4 skateboard bolts of length 1-1/4" with 4 extra nuts and optional washers.

Assembly instructions. 1. Mount your trucks onto your board with no riser pads using 1-1/4'' bolts on the front of the trucks where you will mount the sliders, you can use whatever bolts you like on the back (I use 7/8"). 2. Tighten the front nuts in the orientation so that the flat sides of the nuts are parallel with the front end of the truck (look at the nut holes on the slider and this will make sense) 3. Position the slider in place deep enough to allow another nut to be threaded onto it. 4. Tighten the second nuts (add optional washers) using a socket to push and hold the slider all the way to the board. 5. Go skate and let me know what you think!