Flush-end Ruler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I took the original model and removed the ends to turn it into a flush-end ruler. This way the line starts immediately
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 17
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
This is a ruler model that was modified to make it a flush-end ruler - the measurement starts right at the edge of the ruler rather than there being a gap from the edge to the first measurement line.
I recommend using a lighter color for the body of the ruler itself and then filling in the numbers with a darker color. I went with gray for the ruler and black for the numbers and lines.
Any filament will do. I recommend using a smaller layer height due to the details. I used 0.16mm. This will increase the print time significantly but you'll find that it is worth it.
My printed example is not a reflection of the quality of the model. I realized at the last second I only had so much gray so I had to reduce the amount needed. Your's will be much nicer!