1 / 1
SVI Quickshot II Turbo centering grommet — zdjęcie 1

SVI Quickshot II Turbo centering grommet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The rubber grommet of my QSII dried and literally crubmbled down. this is the repacement.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
31
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Video Games
Licencja
Creative Commons — Attribution — Share Alike

As i stated i needed a new centering grommet so i designed one,  since i had only standard TPU i reduced a little the overall volume and kept radii and height , print with 2 walls and 2 solid top bottom layer. 15% gyroid infill. i compared with another one still ok and is a little bit stiffer ( more or less as i remember them as new) if you need a stiffer (i do not suggest it honestly)  or wearer one modify the infill percentage.

Tight fit is not needed but you might want print upside down and wet sand with 320 grit paper top and bottom if the lever does not get back to the center easily. 

Tagi