SVI Quickshot II Turbo centering grommet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The rubber grommet of my QSII dried and literally crubmbled down. this is the repacement.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 31
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Share Alike
As i stated i needed a new centering grommet so i designed one, since i had only standard TPU i reduced a little the overall volume and kept radii and height , print with 2 walls and 2 solid top bottom layer. 15% gyroid infill. i compared with another one still ok and is a little bit stiffer ( more or less as i remember them as new) if you need a stiffer (i do not suggest it honestly) or wearer one modify the infill percentage.
Tight fit is not needed but you might want print upside down and wet sand with 320 grit paper top and bottom if the lever does not get back to the center easily.