Fuxi H3 / Logitech G435 Headset Hinge Bracket

What this part is
This part sits between the earcup and the headband arm. The ball end goes into the socket of the earcup. The rail end holds the arm. The earcup and the arm hide this part. You see it only when you open the headset.

The problem with the original part
A screw holds the original part inside the earcup. This part is thin, and it breaks. To change the original part, you must open the full headset every time.

What this model changes
You open the headset one time only. After that, the ball of my part is a press fit in the socket. The screw is not necessary.

Then a change takes one step: remove the single screw on the arm, and put in a new part. The earcup stays closed.

This part still breaks after some time. That is the nature of the geometry. But now you print a new one and change it in two minutes.

Fits
Havit Gamenote Fuxi-H3. I own this headset, and I measured it. The part works very well on it.

Can fit
These headsets have a similar body and a similar arm. I do not own them, and I did not test them. If this part fits your headset, write a comment. I add each confirmed model to this list.

• Rampage Crack H11

• Havit Fuxi-H6 and Havit Fuxi-H7

• Attack Shark L80, L80 Pro, and L90 (also sold as MAMBASNAKE or Yindiao)

• Other light wireless gaming headsets that have a fabric headband and the same body

The Logitech G435 and G435s have a similar design. I did not test the joint of these headsets. If you own a G435, measure your broken part before you print.

Note
I am not part of Logitech, Havit, Rampage, or Attack Shark. These companies did not approve this part. The brand names show the fit only.