Silica gel spool-shaped container (filament dehydrator compatible)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spool-shaped container for holding silica gel that can be put in a filament dehydrator to dry the gel out
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This is a bucket for holding a bulk amount of silica gel that fits inside of filament dehydrators for convenient drying. As silica gel drying requires higher temperatures, it is highly recommended that you print it out of ASA or HIPS. The lid attaches using 8 flathead M3x5 screws (though shorter screws may also work).
Also included are a funnel for helping fill or empty it, along with a cap that goes over the center region to minimize spilling while filling or emptying. I recommend printing these out of PETG.
As this will take up most of the volume of a filament dehydrator, please be careful to make sure this doesn't overheat your dehydrator. Keep an eye on it if you're not sure.
The original OpenSCAD file is also included. It requires BOSL2 installed to render.