1 / 10
Radio Shack Soldering Iron Adapter for Dremel 220 Drill Press To Install Heat Set Inserts — zdjęcie 1
1 / 10

Radio Shack Soldering Iron Adapter for Dremel 220 Drill Press To Install Heat Set Inserts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An adapter to attach a triangular shaped Radio Shack soldering iron to a Dremel drill press.

Ocena
0 / 5
Polubienia
4
Pobrania
5
Wydruki
0
Wyświetlenia
86
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

I have the same Radio Shack Soldering iron that BillT used for his mod. I cut the Dremel mockup from Oxyfraggle71's mount and attached the mount from model to fit the soldering iron.

Upon mounting the soldering iron, I discovered that, even at the highest point, there is very little room for the soldering iron tip to travel. In V2, I used the attachment and side plates from BillT's model to raise the soldering iron to a workable height. 

I modified the attachment to accept a M3 nut because that is what I had on hand at the time. I used a M3x25 screw and M3 nut. You can use a M4 screw either with or without a nut, but I found out that if you choose to use a nut, either the head or nut will protrude from the side. I would rather be on the safe side and use a nut than trust the plastic to hold a bare screw. 

See the screenshot for the recommended settings I used for my Adventurer 5m running Flash Studio as the slicer. I found the best orientation is as shown in the photos/screenshot. 

For very easy Support removal, I used Organic Tree. Threshold angle =45. Threshold overlap 50%. First layer density 90%. First Layer expansion=2mm. On build plate only, Support critical regions only, ignore small overhangs all active. Tip diameter = .8mm Branch distance 1mm. Branch density 30%. Branch diameter 2mm. Branch diameter angle 5. Branch angle 40, Preferred branch angle 25. Those settings made the tree removal like butter!

Tagi