Radio Shack Soldering Iron Adapter for Dremel 220 Drill Press To Install Heat Set Inserts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An adapter to attach a triangular shaped Radio Shack soldering iron to a Dremel drill press.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 5
- Makes
- 0
- Views
- 86
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
I have the same Radio Shack Soldering iron that BillT used for his mod. I cut the Dremel mockup from Oxyfraggle71's mount and attached the mount from model to fit the soldering iron.
Upon mounting the soldering iron, I discovered that, even at the highest point, there is very little room for the soldering iron tip to travel. In V2, I used the attachment and side plates from BillT's model to raise the soldering iron to a workable height.
I modified the attachment to accept a M3 nut because that is what I had on hand at the time. I used a M3x25 screw and M3 nut. You can use a M4 screw either with or without a nut, but I found out that if you choose to use a nut, either the head or nut will protrude from the side. I would rather be on the safe side and use a nut than trust the plastic to hold a bare screw.
See the screenshot for the recommended settings I used for my Adventurer 5m running Flash Studio as the slicer. I found the best orientation is as shown in the photos/screenshot.
For very easy Support removal, I used Organic Tree. Threshold angle =45. Threshold overlap 50%. First layer density 90%. First Layer expansion=2mm. On build plate only, Support critical regions only, ignore small overhangs all active. Tip diameter = .8mm Branch distance 1mm. Branch density 30%. Branch diameter 2mm. Branch diameter angle 5. Branch angle 40, Preferred branch angle 25. Those settings made the tree removal like butter!
