1 / 8
Tray with dirt trap for Salt and Pepper grinders — zdjęcie 1
1 / 8

Tray with dirt trap for Salt and Pepper grinders

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A dual part tray for grinders. An upper perforated part and a bottom debris collecting tray sloped towards its center.

Ocena
0 / 5
Polubienia
6
Pobrania
9
Wydruki
0
Wyświetlenia
59
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

We have Salt and Pepper grinders on our kitchen counter for natural reasons. We keep them in a small wooden tray from IKEA. After using them and putting them back in the tray some salt and pepper debris always falls off from the grinders. In time quite a lot of salt and pepper debris accumulate under and around the grinders. Making it look messy and the grinders to stand a bit unstable.

So I made an oval shaped tray which is sloped from both ends towards its center. And an upper perforated tray to place the grinders on, which lets the debris to fall down into the sloped tray below.

The grinders we have are 52 mm in diameter. So if your grinders have a different diameter you need to scale the print up or down based on this diameter.

I printed the bottom tray in Black TPU to get a bit more friction against the tray below. So it doesn’t move around too much when putting back the grinders.

The upper tray I printed in Black ASA, in up-side-down position with just a few tree like supports for the connections between the 2 circular surfaces.

Tagi