Tray with dirt trap for Salt and Pepper grinders
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A dual part tray for grinders. An upper perforated part and a bottom debris collecting tray sloped towards its center.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 9
- Makes
- 0
- Views
- 59
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
We have Salt and Pepper grinders on our kitchen counter for natural reasons. We keep them in a small wooden tray from IKEA. After using them and putting them back in the tray some salt and pepper debris always falls off from the grinders. In time quite a lot of salt and pepper debris accumulate under and around the grinders. Making it look messy and the grinders to stand a bit unstable.
So I made an oval shaped tray which is sloped from both ends towards its center. And an upper perforated tray to place the grinders on, which lets the debris to fall down into the sloped tray below.
The grinders we have are 52 mm in diameter. So if your grinders have a different diameter you need to scale the print up or down based on this diameter.
I printed the bottom tray in Black TPU to get a bit more friction against the tray below. So it doesn’t move around too much when putting back the grinders.
The upper tray I printed in Black ASA, in up-side-down position with just a few tree like supports for the connections between the 2 circular surfaces.