Charging/Data Dock for Xiao nRF Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Charging/Date Cradle for the Xiao nRF enclosure for sma antenna meshtastic meshcore
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 81
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a charging cradle for the Xiao nRF enclosure for sma antenna meshtastic meshcore by @dremial_8 which I created combining the stand and this model by @BradAustin which allows the device to stand upright while charging or while it is hooked up to a computer. It uses these right angle USB-C connectors and the base is secured with 4 x M3-8 screws and 4 x M3-4 heat Inserts.
Print with the flat bottom facing down and supported. The supports aren't the easiest to remove unfortunately, but it'll work. I use 3 interface layers and that helps.
I recommend printing these with at least 3-4 walls as the heat inserts will have a lot of pressure pulling on them as you tighten on the base and I have found they stay in better with more than 2 walls. I also recommend printing at a higher infill for weight and stability.