Sonoff NSPanel Pro 120 – Feller EDIZIOdue Wall Adapter - Captive Nut
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sonoff NSPanel Pro 120 for Swiss 68mm UP-Dose, Feller EDIZIOdue mount. Arc slots with 45° chamfer & captive nut.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 79
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Sonoff NSPanel Pro 120 – Feller EDIZIOdue Wall Adapter
Captive Nut Version
Identical to the Open Nut Pockets version but with fully enclosed captive nut pockets – the M4 nuts are inserted during printing and permanently captured. No glue, no fiddling after printing.
What's Different to the Open Nut Pockets Version
Nut pockets are fully enclosed (1mm floor + 3.1mm cavity + 2.5mm ceiling)
Total height unchanged: 6.6mm
Slicer pause required at Layer 20 (Z=4.1mm)
Print Instructions
Set a pause at Layer 20 (Z=4.1mm) in your slicer
When the printer pauses, insert 2× M4 hex nuts using tweezers
Make sure nuts sit flush in the pockets
Resume print – nuts are permanently captured
Hardware Required
2× M4 hex nut (AF 6.9mm, height 3.1mm)
2× M4 screw
4× Feller EDIZIOdue flat-head screws
Based on
Remix of Sonoff NSPanel Pro 120 UP-Adapter
Designed with AI assistance – Claude by Anthropic
Print Settings:
Layer height: 0.2mm
Infill: 15% Gyroid
No supports needed
Pause at Layer 20 (Z=4.1mm) for nut insertion
Tested on Bambu Lab P1S