CoPrint Printable 8-in-1 Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printable versions of the Coprint Chromahead's 8-in-one adapter.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Printable versions of the Coprint Chromahead's 8-in-one adapter.
Print in 0.1mm layer Height for smooth internal pathways.
Two Versions are available:
Push fit connector; replicating the CoPrint Design
Pneumatic Connector version (recommend 4OD push through type)
Both version feature upgrades to the CoPrint design. THe Pneumatic tubes can now sit deeper into the 8-in-1 adapter, allowing the filament to exit the tube directly into the feed pathway.
The initial design calls for 2ID/4OD tube and positioning the filament travel end slightly outside the tube so it is always parked inside the feed path. This updated version allows for the filament to be parked at any unobstructed depth in or outside the feed pathway and filament will enter smoothly.
Note for Push fit version: Due to internal tolerances and spacing needs, the center hole is a bit tighter than the 7 side holes. Reference the image of the push connector, you will need to use your flush cut cutters to nip off the 4 little nubs on the inside of the PTFE tube holders for that one center insert, otherwise it will grip the tube too tight and will be difficult to remove. Clip them off, no problem.