Hoyt 5 inch Tire, Pulley and Hub Set
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wheel hub and pulley for Hoyt St 5inch Tires.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a custom hub and pulley designed to fit the Hoyt ST 5" tires for riders who can't find or don't want to buy the original Hoyt hardware. The original kit was north of $400 for the aluminum pulley and hub set.
My experience
I'm a 190 lb rider and put about 10 miles on these using a Wowgo AT2+.
The white finish looks great, and being pneumatic they soak up bumps as expected.
Great for carving on a DKP setup.
They do look a bit narrow on the board and I wish they were wider, but they perform great.
Materials
Hub: printed in Siraya Tech Fibreheart ABS-GF (white, glass-fiber reinforced ABS) for strength and heat resistance. After printing, I sanded the hub and coated it in epoxy to lock in the white color, add strength, and give the inner tube a smooth surface to rest against.
Pulley: printed in Elegoo ASA.
Hardware
The hub and pulley require 50mm and 35mm screws for installation. I used this kit from Amazon.
I'd suggest M3 lock nuts to keep the bolts from working themselves free.
Print settings
0.4mm nozzle, "strength" profile
5 wall loops
5 top shell / 3 bottom shell layers, 100% top/bottom density
40% sparse infill, gyroid pattern, 3x fill multiline
Supports required, printed with support ironing for a cleaner finish
Disclaimer
I am not an engineer, and this model has not been fully vetted or tested by a professional testing organization. This is a hobby item, and any injury or damages are not my responsibility. Print and use at your own risk.
