1 / 1
Enclosure for TekOnline ESPHome 8-Zone HVAC Controller V2 – 24VAC Relay Board — zdjęcie 1

Enclosure for TekOnline ESPHome 8-Zone HVAC Controller V2 – 24VAC Relay Board

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Enclosure for TekOnline ESPHome 8-Zone HVAC Controller V2 – 24VAC Relay Board

Ocena
0 / 5
Polubienia
0
Pobrania
10
Wydruki
0
Wyświetlenia
51
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial

This is my first design upload — a simple two-part enclosure (base + snap/screw-fit lid) for the TekOnline 8 Channel 24VAC HVAC Board.

I run mine in the roof space, so the goals were basic: keep dust off the board and keep it away from direct radiant heat. No active or passive vents are included — dust ingress was the bigger concern for this installation than heat dissipation, and testing over summer showed the board sitting around 55°C enclosed, which is comfortably within spec for the board.

Dimensions: ~169 × 92 × 45mm assembled (base + lid).

Print both parts flat on the bed, no supports needed. Standard PLA is fine for a roof-space install unless your local ambient gets considerably hotter than mine — if you're somewhere warmer, I'd size up to PETG or ASA given the 55°C+ operating temps involved.

License: CC BY — feel free to remix or adapt this for your own setup, just credit the original design back to me.