Enclosure for TekOnline ESPHome 8-Zone HVAC Controller V2 – 24VAC Relay Board
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enclosure for TekOnline ESPHome 8-Zone HVAC Controller V2 – 24VAC Relay Board
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 10
- Makes
- 0
- Views
- 51
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
This is my first design upload — a simple two-part enclosure (base + snap/screw-fit lid) for the TekOnline 8 Channel 24VAC HVAC Board.
I run mine in the roof space, so the goals were basic: keep dust off the board and keep it away from direct radiant heat. No active or passive vents are included — dust ingress was the bigger concern for this installation than heat dissipation, and testing over summer showed the board sitting around 55°C enclosed, which is comfortably within spec for the board.
Dimensions: ~169 × 92 × 45mm assembled (base + lid).
Print both parts flat on the bed, no supports needed. Standard PLA is fine for a roof-space install unless your local ambient gets considerably hotter than mine — if you're somewhere warmer, I'd size up to PETG or ASA given the 55°C+ operating temps involved.
License: CC BY — feel free to remix or adapt this for your own setup, just credit the original design back to me.
